Acer PCI Disk Array Controller Drivers 08P4100 Manuel d'utilisateur télécharger pdf (Page 19)

NetWare

Manual No. 775079 2-5

3. Choose “Configure disk and storage device drivers” in the Driver

Options menu.

4. Choose “Select an additional driver” in the Additional Driver Actions

menu.

NetWare scans for controllers that do not have drivers already loaded.

5. At the “Select a driver” box, press <Ins> to choose to install an

unlisted driver.

6. Insert the DOS-formatted NT4/NW Drivers Software Kit diskette into

the diskette drive.

7. Press <F3> to specify the path of the NetWare driver you’re about to

install.

8. Change the path line to read:

A:\netware

and press <Enter>. NetWare scans for drivers on the floppy diskette in

the specified path.

9. In the “Select a driver to install” box, select the appropriate driver for

your controller:

MDAC.HAM | <Controller model number>

10. Select Ye s at the confirmation box to install the driver.

11. Press <Enter> to select the default server boot path.

12. Select Ye s to save a backup of the old or existing driver.

13. Press <Enter> to continue when you see the message that the old

driver will be saved.

NetWare copies the file.

14. What you just backed up was the old or existing .DSK or .HAM file.

Repeat Steps 12 and 13 for the .DDI file.

15. Select No to decline selection of an additional driver to install unless

you are installing more than one Mylex controller at this time.

16. Exit INSTALL.NLM by pressing <Esc> three times, then selecting Ye s

at the “Exit Install?” box.

This concludes installation of the driver files needed to run your Mylex Disk

Array Controller under NetWare 4.2.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 99 100

Pas de commentaire

Acer PCI Disk Array Controller Drivers 08P4100 Manuel d'utilisateur Page 19