Acer Altos G330 MK2 Manuel d'utilisateur télécharger pdf (Page 106)

5 System troubleshooting

Hardware diagnostic testing

This section provides a detailed approach to identifying a hardware

problem and its cause.

Checking the boot-up status

Caution: Before disconnecting any peripheral cables from the

server, turn off the system and any peripheral devices. Failure to

do so can cause permanent damage to the system and/or the

peripheral device.

1 Turn off the system and all external peripheral devices.

2 Disconnect all peripheral devices from the system, except for the

keyboard and the monitor.

3 Make sure the system power cord is plugged into a properly

grounded AC outlet and in the power cable socket.

4 Make sure both the monitor and the keyboard are correctly

connected to the system.

5 Turn on the monitor.

6 Set the display brightness and contrast controls to at least two

thirds of their maximum range.

Refer the documentation that came with your monitor.

7 If the operating system normally loads from the hard drive, make

sure there is no diskette in the FDD and no disc in the ODD.

8 If the power indicator is lit, attempt to boot from a floppy diskette

or from a disc.

9 Turn on the system.

If the power indicator did not light up, see the "Power indicator

does not light" item on page 90.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 124 125

Pas de commentaire

Acer Altos G330 MK2 Manuel d'utilisateur Page 106