Acer Network Device Altos R520 Manuel d'utilisateur télécharger pdf (Page 90)

3 System upgrade

5 Pull up the module to remove it from the connector (B).

6 Observe the post-installation instructions described on page 40.

To install an ARMC/3 module:

Note: Prior to installing the ARMC/3 module module, you must

remove the server management port cover module cover on the

rear of the server.

1 Observe the ESD precautions and pre-installation instructions

described on page 39.

2 Remove the CPU air duct. Perform the instructions described in “To

remove the CPU air duct” section on page 45.

3 Insert the standoff into the hole in the ARMC/3 module. The

standoff installs on the bottom side of the module (A).

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 183 184

Pas de commentaire

Acer Network Device Altos R520 Manuel d'utilisateur Page 90