Acer AB460 F1 Manuel d'utilisateur télécharger pdf (Page 284)

4 Networking Switch Modules

Note: After the module has been installed and the handle locked,

it will turn on and a POST test will run to verify it is working

properly. If there are no problems the blue

Init. OK LED on the

module will illuminate and you will see an

OK under INITIATED in

BE SWITCH screen of the management software utility.

Note: If the module is installed in a top bay it must be positioned

upside-down.

Removing a Switch Module

1. Pull out the release handle to the open position.

2. Pull the module out of the bay.

3. Replace immediately with another module or with a dummy

module cover to maintain airflow integrity.

Pas de commentaire

Acer AB460 F1 Manuel d'utilisateur Page 284