Acer SmartRAID V Manuel d'utilisateur télécharger pdf (Page 100)

5-16

Software Installation

NOTE When you reboot several WARNING messages may appear and

scroll off the screen quickly. These will not occur after

“diskadd” is run and can be ignored.

6. Use the diskadd utility to add drives or arrays that are attached to a

SmartRAID V controller.

Run the sdiconfig –l utility in a terminal window or non-GUI screen.

This will list all controllers recognized by the operating system and

any attached devices. Use this listing to determine the proper ID to

use for the diskadd utility.

The diskadd command to add devices on a secondary controller is:

diskadd c

Where:

C specifies the ID for the controller in the system.

B is the controller bus number (from 0 – 7) to which the disks are

attached.

T is the target controller number (ID). The value of T can be

0 – 31.

D is the Logical Unit Number (LUN) of the disk device, from

0 – 31.

See the diskadd(1M) man page for more information.

For example, if a new drive or array is on the DPT controller, on channel 0,

with an ID of 0, the command would be:

diskadd c1b0t0d0

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 255 256

Pas de commentaire

Acer SmartRAID V Manuel d'utilisateur Page 100