Acer 486 Manuel d'utilisateur télécharger pdf (Page 23)

Am486

Microprocessor PCI Customer Development Platform

1-3

Installation Requirements

You need to provide the following items (in addition to the PCI CDP from the kit).

Required for all setups:

• A VGA-compatible monitor

• A PCI- or ISA-bus video card that supports VGA

• A cable to connect the monitor to the video card

• An AT-compatible keyboard

• A PS/2-style mouse (if needed for your operating system)

• A standard AT-style power supply

To boot from a floppy diskette:

• An AT-compatible 3.5-inch or 5.25-inch diskette drive

• A bootable DOS diskette

• A standard 34-wire AT diskette drive cable

To boot from a hard disk drive:

• An ATA-compatible hard disk drive

• AT-compatible operating system (preinstalled on the hard disk drive)

• A standard 40-pin ATA HDD cable

If you install both a floppy diskette drive and a hard disk drive, you can boot from

either device. Only one boot disk image (floppy or hard disk) is required. For

example, you can boot from the floppy and then install the operating system on a

blank hard disk drive.

CAUTION: Use the configuration described here when you first

start the PCI CDP. Before using other features, read the

appropriate sections in Chapter 2, “Board Functional

Description.”

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 109 110

Pas de commentaire

Acer 486 Manuel d'utilisateur Page 23