Acer 486 Manuel d'utilisateur télécharger pdf (Page 26)

Am486

Microprocessor PCI Customer Development Platform User’s Manual

1-6

Starting from Diskette

Use the following steps to start the PCI CDP from a bootable diskette:

1. Make sure you have installed the PCI CDP correctly as described in “Setting

Up the PCI CDP” on page 1-2.

CAUTION: Failure to verify the power supply connections can

result in total destruction of the PCI CDP.

2. Plug the VGA monitor into an electrical outlet and turn it on.

3. Insert a bootable DOS diskette (not included) in the disk drive.

4. Apply power to the PCI CDP by connecting the PC power supply to an electrical

outlet. If the power supply is equipped with a switch, turn it on.

The power supply fan should start running, and the port 80h LEDs should start

to display power-on self-test (POST) status codes. Then the speaker should

beep and the monitor should start displaying startup information.

Make sure the CPU heat sink fan is running. Do not operate the microprocessor

without a functioning heat sink fan.

5. The first time you start the system, the BIOS might display a message reporting

a CMOS error or some other BIOS configuration problem. Follow the

instructions shown on the screen to enter the Setup utility. Once you are in the

Setup utility, you can set the system’s date, time, startup drive, and other

options.

For more information on the included BIOS, see the online BIOS manual

included with your kit.

6. Save and exit the setup utility.

7. The system should now boot from the DOS diskette just like a standard PC. If

you encounter any problems, see “Installation Troubleshooting” on page 1-8.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 109 110

Pas de commentaire

Acer 486 Manuel d'utilisateur Page 26